Photo Crystal Machine

1.Stylish and Graceful

This machine is made of aluminum alloy which only weights 11 kg, and the size is 550*550*235mm.

2.Economize Energy & Efficient

The power of the machine is only 64 watt. Low heat, no radiator. All the lamps and the socket are of high quality with CE Approval.

3.Facilitate Durable, Life Long, Ater-Sale Service

Lamps can light up for 20,000 hours.

4.Smart Design and Multifunctional, Easy to Use

The front lamp is the solidification lamp. It is smart designed so it is very convenient for solidifying the pedestal of the crystal products as well as easily being transported. You can easily take it to anywhere. The front lamp which is used to solidify the pedestal of the crystal can be replaced easily. If you order more than ten sets we can design the special logo for you. We provide different types of sockets suitable for different countries.

5.Warranty: machine 1year ,heater 3 month

1.At the very beginning, please put a ceramic tile covered by a clean and wet cloth on the worktable.

2.Drop some transparent glue on the crystal.

3.Stick the film of the photo side to the crystal.

4.Spread the glue slightly by a ruler. Please make sure no bubbles.

5.Turn on the crystal solidification machine and put the crystal in.

6.Set the time to be 4 minutes. If the crystal is big, set the time longer.

7.It will alarm after five or six minutes, then turn off the timer and the lamps and take the crystal out.

8.Erase the overflowing glue with clean paper or cloth. Then trim the crystal along the crystal edges.

9.Tear off the thin cover of the film.

10. Smoothen the edges of the crystal at 45 angles with a sharp knife.

11.Put the crystal on the ceramic board horizontally, stick the same shape glass sheet to the crystal slightly. Please note that don’t press the crystal by hand too much.

12.Put the crystal with glass sheet into the machine. After 2 minutes, take it out and clean it. Again put it into the machine, 7 minutes later, take it out. Finish.